Played once when the train sways to the right side.Дefines a set of sounds played in a loop as instructed by the train.dat. Played once when the train sways to the left side. The non-negative integer i corresponds to the Train.Run command in CSV routes where route developers can select which of the runi.wav sounds to play for a certain type of rail. The recordings should correspond to a speed of 90 km/h. The sounds are played at a pitch proportional to the speed. The sound is played at a pitch inversely proportional to the speed, and the volume of the sound decreases with increasing speeds.Дefines a set of sounds played in a loop for the duration the train moves. Played in a loop when the brake shoe rubs against the wheels. Played once per axle when the train crosses a pointwork. Played in a loop all the time for the duration of the simulation. The non-negative integer i corresponds to the Train.Flange command in CSV routes where route developers can select which of the flangei.wav sounds to play for a certain type of rail. The recordings should correspond to a speed of 45 km/h. Played once when the emergency brakes are activated.Дefines a set of sounds played in a loop when the flange of the wheels rub against the rails. Played once when the air compressor is deactivated. Played in a loop for the duration the air compressor is active. Played once when the air compressor is activated. Played occasionally when the pressure in the brake cylinder is decreased to zero value. Played occasionally when the pressure in the brake cylinder is decreased from a high value. Played occasionally when the pressure in the brake cylinder is decreased from a non-high value to a non-zero value. Sounds played on all cars where applicable air.wav Played once when the built-in security system is switched from ATS to ATC. Played once when the built-in security system is switched from ATC to ATS. Played in a loop when the music horn is applied. Played once when the secondary horn is applied. Played once when the primary horn is applied. Played once or in a loop (depending on the train.dat setting) when the pass alarm system warns about an approaching station stop. Played in a loop when the built-in EB system rings. when ATS-P activates the PTN APPROACH lamp, or when ATC changes the current speed restriction. Played once when the built-in security systems ATS-P or ATC change some states, e.g. For other trains, is played when the brake notch is decreased. This happens after acknowledging the bell when passing S-type transponders.ДЇor trains with automatic air brake, is played when the handle is moved into the SRV or EMG position. Played in a loop when the built-in security system ATS rings its chime. This happens when passing certain transponders or when the security system is deactivated but power is applied. Played in a loop when the built-in security system ATS rings its bell. Played once when the train stops at a station, but needs to correct its stop position. 2 Sounds played on all cars where applicable.

Bvestation 6 train